The 1.5KE33A is a single-phase unidirectional Transient Voltage Suppressor (TVS) Diode with an UL94V-0 molded plastic case.

• Glass passivated chip
• Low leakage
• Excellent clamping capability
• Fast response time
• 5A at 28.2V Maximum reverse leakage current
• Multicomp products are rated 4.6 out of 5 stars
• 12 month limited warranty *view Terms & Conditions for details
• 96% of customers would recommend to a friend

The SMCJ28CA from Littelfuse is a SMCJ series 1500W, surface mount bidirectional transient voltage suppression diode in DO-214AB package. It features excellent clamping capability, low incremental surge resistance, low profile package, moulded plastic body over glass passivated junction, built-in strain relief and fast response time of typically less than 1.0ps from 0Vs to BV minimum. The peak pulse power dissipation (PPPM) is 1500W at TA=25°C, 10/1000μs waveform, 0.01% repetition rate (duty cycle) and power dissipation is 6.5W on infinite heat sink at TL=50°C. This SMCJ series transient voltage suppression diode is designed specifically to protect sensitive electronic equipment from voltage transients induced by lightning and other transient voltage events. It is ideal for the protection of I/O interfaces, VCC bus and other vulnerable circuits.

• Reverse stand off voltage (VR) of 28V and maximum reverse leakage (IR) of 1µA at VR
• Breakdown voltage (VBR) of 31.1V minimum, 34.4V maximum at 1mA test current (IT)
• Maximum clamping voltage (VC) of 45.4V at IPP and maximum peak pulse current (IPP) of 33.1A
• Typical failure mode is short from over specified voltage or current
• UL E230531 approved, plastic package is flammability rated V-0 per UL standard
• IEC-61000-4-2 ESD 30KV (air), 30KV (contact) protection
• Suitable for surface mounted applications to optimize board space
• Operating temperature range from -65°C to 150°C and 260°C/40sec high temperature to reflow soldering
• ESD protection of data lines with IEC 61000-4-2 and EFT protection with IEC 61000-4-4 standard

The TRANSZORB 1.5KE series Transient Voltage Suppressor Diode offers 1500W peak pulse power capability with a 10/1000μs waveform, 0.01% repetitive rate (duty cycle). It is used in sensitive electronics protection against voltage transients induced by inductive load switching and lighting on ICs, MOSFET and signal lines of sensor units.

• Glass passivated chip junction
• Available in unidirectional and bidirectional
• Excellent clamping capability
• Very fast response time
• Low incremental surge resistance
• -55 to 175°C Operating junction temperature range