|Manufacturer Part Number||USL20-30S-050-C|
|Description||0.4mm Pitch I.D.C. Connector for Micro Coaxial Cable|
USL Series of I.D.C. connectors provides support for 0.4-mm pitch, ultra-fine coaxial cables (#42 AWG) and makes full use of KEL`s technical expertise in batch assembly for the purpose of cable connection.
During the development process, considerable effort was placed on the perfecting of a series of connectors that – particularly in terms of data-transmission – would minimize the degree to which the beneficial characteristics of the coaxial cable were affected. encasing the board-side connector in a metallic shell, we achieved simultaneous improvements in noise resistance, component strength, and grounding performance.
The connectors of this series have a pitch of 0.4 mm and a low mounting height of 1.0 mm.
When compared with our current SSL Series of connectors for 0.5-mm pitch, ultra-fine coaxial cables, the USL Series achieves a major reduction of approximately 50% in terms of coupled volume, thus contributing greatly to weight reduction and device miniaturization. This product features a right-angle type connector on the board side and a straight type on the cable side; furthermore, 30- and 40-contact variations are currently available.
TE Connectivity / Raychem 44A0111-12-00 out of 5(0)
The 44A0111 series from TE Connectivity are hook up wires. These Hook up wire features outstanding physical and electrical characteristics of radiation, highly flame retardant, non melting, does not cold flow and mechanically easy handling. Designed mainly for military application where high density and complex circuitry are required.
- CPR: Not Yet Qualified
- Single primary wire
- Tin coated copper conductor
- Unshielded & unjacketed cable
- Conductor size of 30AWG to 8AWG
- Operating temperature range -65°C to 150°C
- Primary wire insulation are available in multiple colour
- Small size, light weight
- Resistant to most chemicals
- Low smoke and low corrosive gas generation
Belden 1325A 00910000 out of 5(0)
The 1325A 0091000 is a 2-pair Shielded Cable with 22AWG stranded bare copper conductors and Flamarrest® flame-retardant polyvinyl chloride insulation. This plenum-CMP multi-conductor cable comes with a Beldfoil® aluminum foil-polyester tape shield and white Flamarrest® flame-retardant polyvinyl chloride jacket. Belden multi-conductor cable delivers low voltage analog data and signal transmission within enclosures from controllers and I/O’s to devices such as temperature and pressure sensors, relays, valves, meters, thermocouples, solenoids, actuators, contactors, push buttons and alarms.
- 120.101N Maximum recommended pulling tension
- 111.554pF/m Nominal mutual capacitance
- 48.2307Ω/km at 20°C Nominal conductor DC resistance (DCR)
- 0 to 75°C Operating temperature range